Will C156E-00 clear itself on a Jeep Grand Cherokee?

If the underlying fault was a momentary glitch — for example a brief connector dropout or a one-time low-voltage event — the C156E-00 may clear after a few drive cycles. Persistent root causes (failed device, broken wire, corroded terminal) will keep the fault active until the affected component is repaired on the Jeep Grand Cherokee.

Can I drive my Jeep Grand Cherokee with C156E-00 active?

It depends which subsystem is affected. If the C156E-00 is in a primary safety system (brakes, restraints, steering, air suspension), the Jeep Grand Cherokee should be driven only to a workshop. Comfort, lighting, and audio faults are lower priority but still worth addressing — the Jeep Grand Cherokee's CAN architecture means a single unresolved code can mask others.

How much does it cost to fix C156E-00 on a Jeep Grand Cherokee?

Repair cost depends on the named device. On the Jeep Grand Cherokee, simple connector or wiring repairs typically run $80-200 in shop labour. Sensor replacements run $120-450 including parts and diagnostic time. Module replacement (when the affected control module itself has failed) is the most expensive path at $400-1,200 depending on whether the new module needs programming. Get a written estimate that breaks out diagnosis time, parts, and any required PMI / programming charge.

What does the official Jeep Grand Cherokee service definition say about C156E-00?

Per the factory service information, C156E-00 is defined as: Ride Height System Calibration Performance. The diagnostic procedure is in the Jeep Grand Cherokee service-manual chapter for the affected module.

C156E-00 Jeep Grand Cherokee – Ride Height System Calibration Performance

C0020 ABS Pump Motor Control-general Electrical Failure
C0021 Brake Booster-general Signal Failure
C0031 Left Front Wheel Speed Sensor-circuit Current Out Of Range
C0034 Right Front Wheel Speed Sensor-circuit Current Out Of Range
C0037 Left Rear Wheel Speed Sensor-circuit Current Out Of Range
C003A Right Rear Wheel Speed Sensor-circuit Current Out Of Range
C0040 Brake Pedal Switch-signal Invalid
C0044 Brake Pressure Sensor 1 - General Electrical Failure

View all Jeep codes →

Browse by System

Powertrain (P-Codes)
Body (B-Codes)
Chassis (C-Codes)
Network (U-Codes)

More Jeep Codes

Powertrain Systems

More Systems

Safety & Chassis

Chassis & Network