P2102 Toyota Corolla – Throttle Actuator Control Motor Circuit Low

Toyota-specific code — factory diagnostic data

Last updated: May 30, 2026

Definition source: Toyota factory description. Diagnostic guidance is based on factory-defined fault logic for this code.

P2102 on the 2014 Toyota Corolla means: Throttle Actuator Control Motor Circuit Low. It is a circuit low code reported by the SFI System.

🔍Decode any Toyota Corolla VIN — free recalls, specs & safety ratings — free VIN decoder with NHTSA data

↗Looking for the cross-vehicle definition? Read the generic P2102 article for the SAE-defined fault logic that applies to all manufacturers.

P2102 Quick Answer

P2102 on a 2014 Toyota Corolla indicates Throttle Actuator Control Motor Circuit Low. Start with a freeze-frame check and a careful inspection of the connector and wiring at the affected device before replacing any parts.

What Does P2102 Mean on a Toyota Corolla?

On the 2014 Toyota Corolla, the SFI System sets P2102 when it detects a fault matching its official definition: Throttle Actuator Control Motor Circuit Low. This is a manufacturer-specific definition from Toyota factory diagnostic data and applies to the ZRE172-generation Corolla.

Symptoms

• Warning light for the affected system (check engine, ABS, airbag, or a system indicator depending on the module)
• Reduced or lost function of the sfi system
• Possible related codes from other modules on the Corolla CAN/LIN network

Common Causes

• Fault in the component named in the definition (throttle actuator control motor circuit low)
• Open, shorted, or high-resistance wiring in the affected circuit
• Connector corrosion, water ingress, or a backed-out terminal
• Loss of supply voltage or a poor ground at the device
• Module internal fault — confirm wiring and supplies before condemning the module

Diagnostic Approach

For P2102 on the 2014 Toyota Corolla you’ll want an OBD-II scan tool with live-data and freeze-frame support (a Toyota Techstream-class tool reads enhanced data), plus a digital multimeter and the Corolla wiring diagram.

• Confirm the code is current, not stored history, and record freeze-frame data.
• Read all modules — related codes often pinpoint the root cause faster than the headline code.
• Inspect and wiggle-test the connector at the named device while watching live data.
• Measure supply voltage and ground integrity at the device; verify the circuit against the Corolla wiring diagram.
• Substitute or isolate the suspect device only after wiring and supplies check out.
• Clear the code and road-test through one or two drive cycles to confirm the repair.

Possible Fixes

• Repair open/short/high-resistance wiring or a corroded connector
• Restore supply voltage or ground at the affected device
• Replace the failed component named in the definition
• Replace and, where required, initialise/program the module if it is internally faulty

Can I Still Drive With P2102?

It depends on the system. SFI System faults that affect braking, the airbag/restraint system, power steering, or stability control should be repaired before further driving. Comfort or convenience faults can usually be deferred briefly, but related codes can mask one another on the Corolla network — diagnose promptly.

Source

Code definition from 2014 Toyota Corolla (ZRE172) factory diagnostic information (SFI System). Symptom, cause, and diagnosis guidance summarised from standard OBD-II diagnostic practice for this platform.