B2007 Toyota Sienna – Open in Seat Belt Motor LH Circuit

Toyota-specific code — factory diagnostic data

Last updated: May 31, 2026

Definition source: Toyota factory description. Diagnostic guidance is based on factory-defined fault logic for this code.

B2007 on the 2014 Toyota Sienna means: Open in Seat Belt Motor LH Circuit. It is a circuit open code reported by the Pre-collision System.

🔍Decode any Toyota Sienna VIN — free recalls, specs & safety ratings — free VIN decoder with NHTSA data

B2007 Quick Answer

B2007 on a 2014 Toyota Sienna indicates Open in Seat Belt Motor LH Circuit. Start with a freeze-frame check and a careful inspection of the connector and wiring at the affected device before replacing any parts.

What Does B2007 Mean on a Toyota Sienna?

On the 2014 Toyota Sienna, the Pre-collision System sets B2007 when it detects a fault matching its official definition: Open in Seat Belt Motor LH Circuit. This is a manufacturer-specific definition from Toyota factory diagnostic data and applies to the XL30-generation Sienna.

Symptoms

• Warning light for the affected system (check engine, ABS, airbag, or a system indicator depending on the module)
• Reduced or lost function of the pre-collision system
• Possible related codes from other modules on the Sienna CAN/LIN network

Common Causes

• Fault in the component named in the definition (open in seat belt motor lh circuit)
• Open, shorted, or high-resistance wiring in the affected circuit
• Connector corrosion, water ingress, or a backed-out terminal
• Loss of supply voltage or a poor ground at the device
• Module internal fault — confirm wiring and supplies before condemning the module

Diagnostic Approach

For B2007 on the 2014 Toyota Sienna you’ll want a scan tool with Toyota-enhanced coverage (Techstream-class) — generic OBD-II readers usually will not read B-codes — plus a digital multimeter and the wiring diagram.

• Confirm the code is current, not stored history, and record freeze-frame data.
• Read all modules — related codes often pinpoint the root cause faster than the headline code.
• Inspect and wiggle-test the connector at the named device while watching live data.
• Measure supply voltage and ground integrity at the device; verify the circuit against the Sienna wiring diagram.
• Substitute or isolate the suspect device only after wiring and supplies check out.
• Clear the code and road-test through one or two drive cycles to confirm the repair.

Possible Fixes

• Repair open/short/high-resistance wiring or a corroded connector
• Restore supply voltage or ground at the affected device
• Replace the failed component named in the definition
• Replace and, where required, initialise/program the module if it is internally faulty

Can I Still Drive With B2007?

It depends on the system. Pre-collision System faults that affect braking, the airbag/restraint system, power steering, or stability control should be repaired before further driving. Comfort or convenience faults can usually be deferred briefly, but related codes can mask one another on the Sienna network — diagnose promptly.

Source

Code definition from 2014 Toyota Sienna (XL30) factory diagnostic information (Pre-collision System). Symptom, cause, and diagnosis guidance summarised from standard OBD-II diagnostic practice for this platform.