On the GJ Mazda 6 the reset method depends on whether the car has Mazda Connect. On 2014-on cars with the touchscreen, go to Applications (or Information) → Vehicle Status Monitor → Maintenance, choose the item (e.g. Oil Change) and select Reset. On early/pre-Connect cars, hold the cluster TRIP button while switching the ignition on, cycle to the wrench icon and hold to reset. No tools are needed.
Overview
The current-generation Mazda 6 (GJ) shows a maintenance message when it reaches a service interval. Mazda Connect arrived on the GJ around the 2014 facelift, which split the reset into two methods: newer cars do it on the touchscreen, while early 2013 cars and any without Connect use the instrument-cluster buttons. It is a scheduling reminder, not a fault warning.
Applies to
2012-present Mazda 6 (GJ/GL). Cars with Mazda Connect (roughly 2014 onward) use the touchscreen method; early 2013 and any non-Connect cars use the cluster-button method. Menu wording drifts by model year (Applications vs Information; 'Maintenance' vs 'Vehicle Maintenance').
What you’ll need
- No tools or scan tool required
Step-by-step
- Mazda Connect cars: open the vehicle menu — With the ignition on, from the Home/menu screen open Applications (or Information on some builds).
- Open Vehicle Status Monitor → Maintenance — Select Vehicle Status Monitor, then Maintenance (Vehicle Maintenance). If it is not under Applications, look under Settings → Vehicle → Maintenance.
- Choose the item and Reset — Select the maintenance item (for example Oil Change or Tyre Rotation) and choose Reset; confirm.
- Pre-Connect cars: use the cluster TRIP button — Switch the ignition off. Press and hold the cluster TRIP/INFO button (labelled TRIP, INFO or a wrench icon; SELECT/RESET on some), turn the ignition on (engine off) while holding, and keep holding until the maintenance/wrench indicator flashes.
- Cycle to the wrench and confirm — Press TRIP to move to the wrench icon, hold again until it flashes and then clears. Switch the ignition off and on to confirm the message is gone.
Important
- Reset the message only after the service has been done — the counter tracks a real maintenance interval.
- For the cluster-button method, do it with the ignition on and the engine off; if it does not take, repeat, then verify by cycling the ignition.
- If a warning light stays on after resetting, that is a fault rather than a service message and needs the diagnostic trouble codes read.
FAQ
Does my Mazda 6 reset on the screen or with buttons?
If it has the Mazda Connect touchscreen (roughly 2014 onward), reset it on screen via Vehicle Status Monitor → Maintenance. If it is an early 2013 car or has no Connect, use the instrument-cluster TRIP-button method.
Where is Vehicle Status Monitor on Mazda Connect?
It is usually under Applications, sometimes under Information or Settings → Vehicle. Menu names vary slightly by model year, so check those areas if it is not where expected.
Do I need a scan tool to reset the Mazda 6 service message?
No. Both the touchscreen and the cluster-button methods are done from the driver's seat without any tool.
The maintenance message won't clear — what now?
On cluster-button cars it can take a couple of attempts; make sure the ignition is on with the engine off. If a warning lamp is lit rather than a maintenance message, that is a fault and needs diagnosing.